3000w Autarky Multiplus 2 Solar System with flat-mount loaded Battery Rack
This is a complete pre wired / pre mounted ready to install 12v Solar System - It includes 552 AH of flat pack big battery razor Lithium batteries - and five 200 Watt roof mount solar panels. It also includes Victrons Touch control panel and Cerbo control system to monitor power / tank levels / and much more. Plenty of power for 95% of all builds, this kit can easily support full-time travel!
Every Device (other than the batteries and solar panels!) is tapped and mounted down to a 1/4 thick aluminum board. This board can be mounted flat - upright either horizontal or vertical - or upside down. All mounting hardware is included. The board is designed to maximize safety and minimize the overall footprint required. The system is made using marine quality fused components from Blue Sea and features high quality hand crimped connections utilizing Temco Cable and terminals. The System is ready to connect in a few easy steps to your vehicles existing 12v charging system - utilizing a Victron 30 Amp DC to DC charger.
Board Dimensions: 30" x 52" x 10" including batteries and rack!
Simple Plug and Play inputs for all circuits-
Easy inputs for: Grounding Cable, Alternator Wire, Shore power Plug, Solar Wire, and Battery Cables.
(6) Dedicated 120v Circuits
(12) Dedicated 12v DC Distribution Circuits
Typical installation can be easily completed within a weekend
Autarky Expedition Vehicles latest Plug and Play solar build. This particular kit shown includes 552 AH of lithium batteries at 12v , 3000w multiplus 2, lynx distribution power in / shunt / fused output / SPod digital switching / progressive dynamics 12v & 120v camper distribution/ 1600w solar capacity via 150/100 smart solar / Cerbo communications with GX touch and ruvi wireless sensors. 100% USA made cable components from the comscope shielded hand crimped rj45 network cable to the braided heat shrunk 4/0 hydraulic crimped inverter cables. Every lug torqued to spec, every device programmed and tested before shipment. Capable of powering virtually any off-grid application from overland travel to remote cabin sites.
Kit arrives completed as shown. Includes battery rack and all hardware for wall mounting. Rack and panel are 100% aluminum anodized or marine poly coated to eliminate surface conductivity. All devices are tapped to the 1/4 aluminum panel forming a common earth bond between all devices. Batteries load individually into rack system for fast and simple mounting. Board is attached to rack using vibration resistive compression fasteners. Entire kit weighs less than 300lb and can be mounted in virtually any orientation. Total footprint is 30" wide x 52" tall x 10" depth. Every kit includes remote monitoring through the victron online VMS portal. Available only through Autarky Expedition Vehicles in Fallon, NV